Nukeproof Generator Rear XL Hub

Nukeproof Generator Rear XL Hub

Nukeproof Generator 150mm x 12mm rear hubs are essential components for any high-grade wheelset, providing smooth and long-lasting bearing performance and a light weight that belies their ability to take hard knocks.

Designed for bikes with oversized 150mm rear dropout spacing and 12mm rear thru-axle.

A tough but lightweight 7075-series aluminium main hub body features cold-forged construction for optimum strength and fatigue resistance while extensive CNC machining shaves excess weight without compromising structural integrity.

The hub features a total of six sealed cartridge bearings: two on either side of the hub body and a further two in the freehub body.

A low friction seal between the bearings and freehub body eliminates contamination of the bearings from ingress of water and dust.

Six pawls with leaf springs are located in the main hub body for ease of maintenance and engage into a 30-tooth steel ratchet in the alloy freehub body for additional strength and increased leverage ratio, which provides positive engagement and super fast pick up for increased acceleration.

The alloy cassette carrier has been cold forged with extensive CNC machining to exacting tolerances and features a hard anodized finish for durability and strength.

Featuring new graphics for 2013 and available in black, silver or Nukeproof yellow.

Nukeproof Generator Rear XL Hub Features:

• 7075 alloy main hub body
• 7075 alloy sub axle
• 5 x Sealed 6902 & 1 x sealed 15268 bearings
• Alloy freehub body with 30T steel ratchet
• 6 pawls with leaf springs
• 5 x Sealed 6902 & 1 x sealed 15268 bearings
• 32-hole
• International Standard 6-bolt disc brake interface
• New graphics for 2013
• Designed to fit frames with 150mm hub spacing and wheels with 12mm thru-axle.

Nukeproof Generator Rear XL Hub Specifications:

• Width: 150mm
• 67mm flange diameter
• Spoke PCD 58mm, spoke hole diameter 2.3mm
• Left side Axle edge-to-flange diameter: 38.5mm
• Right side Axle edge-to-flange diameter: 47.5mm
• 15.25mm end of axle to disc mount face
• Weight: 330g

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: